This solution might help if you try to fix Nokia X7-00 camera hardware failure. This only works if you've already calibrated its firmware and doesn't found out the fix on it. This solution shows the common areas where you may start out to have a check up procedures if trying to repair a camera problem on Nokia X7-00.
Locate these components area in the PCB board for this holds the camera power circuit of the X7-00. These components were oftentimes cause the failure if being damaged caused by wet or water damaged.
The IC's are the camera power voltage drivers, these is driven with the battery 3.7 volts input voltage and having an output of 2.8V VCAM and 1.8 V VDIG which is the supply voltage of the camera module.
You might check this components, trace and check the input 3.7V battery voltage and output voltage values. If the 1.8V is not present, replace the VDIG DC driver and then if the 2.8V is not present replace the VCAM DC driver.
Locate these components area in the PCB board for this holds the camera power circuit of the X7-00. These components were oftentimes cause the failure if being damaged caused by wet or water damaged.
The IC's are the camera power voltage drivers, these is driven with the battery 3.7 volts input voltage and having an output of 2.8V VCAM and 1.8 V VDIG which is the supply voltage of the camera module.
 |
| Nokia X7-00 Camera problem Solution |
View larger image here.
You might check this components, trace and check the input 3.7V battery voltage and output voltage values. If the 1.8V is not present, replace the VDIG DC driver and then if the 2.8V is not present replace the VCAM DC driver.
0 comments "Nokia X7-00 Camera Hardware Failure Solution", Baca atau Masukkan Komentar
Post a Comment