Here's the Nokia N95 / N95 8GB solution for damaged or lifted power ON and OFF button switch. This may helpful for quick repair on a lifted power switch terminal solder pads to restore back the power switch connection line paths without digging the PCB board.
Just refer to the solution below and locate the highlighted test spots or pin-out where to establish and solder the jumper.
The two upper or legs of the power switch is connected to the PCB's ground lines.
The other two which is in lower is the power switch line paths, just locate the test spots as shown on the solution above where to apply a jumper to reconnect it connection. This may work on Nokia N95 and Nokia N95 8GB power ON-OFF button switch if damaged or already lifted. .
Just refer to the solution below and locate the highlighted test spots or pin-out where to establish and solder the jumper.
Nokia N95 / N95 8GB Power Switch Jumper Solution
The two upper or legs of the power switch is connected to the PCB's ground lines.
The other two which is in lower is the power switch line paths, just locate the test spots as shown on the solution above where to apply a jumper to reconnect it connection. This may work on Nokia N95 and Nokia N95 8GB power ON-OFF button switch if damaged or already lifted. .
0 comments "Nokia N95 (8GB) Power ON-OFF Switch Jumper Ways Solution", Baca atau Masukkan Komentar
Post a Comment